bing tracking image

Filter Questions and Answers:

reset filter

Expert Answers about Grand Design Solitude Fifth Wheel


  • Replacement Top for Furrion Range Oven in 2019 Grand Design Solitude 5th Wheel
  • The Replacement Stainless Steel Top with Glass Cover for Furrion 2-in-1 Range Oven # C-FSRE21SA-SS-003 is designed to fit Furrion models FSRE17SASS, F1S21L02A-SS, or FSRE21SASS. The part number you have there, FDO12A-SS, is actually the Front Panel for Furrion 2-in-1 Range Oven Drawer. The front panel corresponds with some of the same range ovens, but not all of them so I can't confirm if it will work based on that part number. If you find that you have one of these model numbers then this...
    view full answer...

  • Replacement Circuit Board and Rain Sensor for MaxxFan Plus
  • The MaxxFan Plus Roof Vent w/ 12V Fan, Thermostat, and Remote - Powered Lift - 10 Speed - Smoke # MA00-04500K is the similar fan to the 4951ksc. The issue you are having with the fan and lid are likely the circuit board which can be replaced with # MA10A21275K. However, the issue could be as simple as replacing the rain sensor. The Replacement Rain Sensor for MaxxAir RV or Trailer Roof Vent Fans # MA34FR is what you need for that and the rain sensor going bad causes the lid to close...
    view full answer...

  • Replacing Sensor Caps On A Tire Minder TM-77
  • We do carry replacement sensors for your Tire Minder TM-77. Unfortunately the caps are not available by themselves. So buying new caps would be your best bet. The sensors are sold in sets of two. Both the # TM-2Brass and the # TM-2ALUM sensors will be compatible with your TM-77.
    view full answer...

  • Replacement Brakes and Hub/Drums for Lippert 298276 and 122463
  • The correct replacement hub and drum assembly for your Lippert 122463 is part # AKHD-655-6-K for a regular grease cap or part # AKHD-655-6-EZ-K for an E-Z Lube grease cap. For replacement brakes the correct part is # AKEBRK-7-SA.
    view full answer...

  • Replacement Puck Light for Ceiling 4-1/2 LED
  • We have the Gustafson RV LED Puck Light w/ Button - Surface Mount, # 277-000489, that is 4-3/8" diameter. Note the attached product review video. If your current puck light is a surface mount then smaller diameter difference should not make a difference. The size difference and need to match more closely comes in to play when there is a cutout dimension that needs to be matched. This also has the on/off button in the center which I like. This allows you to wire each light and turn on/off...
    view full answer...

  • Replacement Lead Leg For Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System
  • Yes, we do have replacement parts available. If I am following you correctly, you are looking for the replacement lead leg for your Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System, # LC675817. This will be part number, # LC305340.
    view full answer...

  • Replacement Control Panel for Lippert 6-Point Leveling System on a 2016 Grand Design Solitude
  • Yes, the Replacement Control Panel for Lippert Ground Control 3.0 and Travel Trailer RV Leveling System # LC421484 is the correct replacement control panel for the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System (6-point) # LC675817.
    view full answer...

  • Replacement for MaxxAir Circuit Board 10A04751KS
  • You can use the Replacement Printed Circuit Board for MaxxAir MaxxFan Plus Roof Vents # MA10A04751KS to replace your damaged 10A04751ksz MaxxAir circuit board. This is a direct replacement.
    view full answer...

  • Replacement Propane Hose For A 2021 Grand Design Reflection 32 MKS 5th Wheel Trailer
  • Based on the pictures you've provided it looks like a 3/8" female swivel fitting on both ends of the hose with straight male fitting and male elbow fitting so you'd need something like the MB Sturgis Propane Hose - 3/8" Female Flare Swivel x 3/8" Female Flare Swivel - 10' # MBS84FR. Before purchasing you'll want to measure the fittings to ensure that they're 3/8 and not 1/2" and check if they are NPT or Flare fittings (based on the pictures I have below). If you disconnect the little adapters...
    view full answer...

  • Should I Replace The Equalizers With The Shackle Link Kit On a 2014 Grand Design Solitude 369RL?
  • Unless your Equa-Flex Cushioned Equalizers # LC279688 are worn out or damaged you would only need to replace the Shackle Kit # MR58ZR on your 2014 Grand Design Solitude 369RL. I do not see that your current equalizers are damaged they only appear to have surface rust. If you can see any damage to the rubber cushioning or severe rust then they should be replaced as well.
    view full answer...

  • Replacement Lens For A 2018 Grand Design Solitude 373FB Ova; Flood Light
  • We do carry the lens for the Gustafson 12V RV Porch Light # 277-000485 you were looking at with part # 291-000002. I was able to find a dimensional drawing of the lens for your current light but I do have the measurements for the lens (pictured below). I recommend measuring the lens area of your light so we can confirm the fitment.
    view full answer...

  • Rebuild Kit Bristol 1-1/2 Gate Valve
  • We have several replacement valve options for RV gray water, 1-1/2" all in black, such as the Bristol Waste Valve for RV Gray Water Tank - 1-1/2" Diameter - Hub to Spigot Item # 34466N11AB or the # 34466N11AB72GMA with a 72" cable. So although do not have a rebuild kit for a Bristol valve in white we do have replacement options. There is also a number of very cost effect replacements in the option of double valves, please note the attached link.
    view full answer...

  • Replacement Grease Seal and Bearing Kit For a 2020 Grand Design Solitude 375RES With 7,000LB Axles
  • Your Dexter axle on your 2020 Grand Design Solitude does use the Grease Seal # GS-2250DL. This seal is also found in our Bearing Kit # BK3-200 which I do recommend keeping on hand incase you have an issue while on the road. The kit contains the Seal # GS-2250DL, Inner Bearing # 25580, Inner Race # 25520, Outer Bearing # 14125A, and Outer Race # 14276. We also have the Spindle Nut Kit # RG05-100 in the event the nut, washer and retainer are somehow damaged. The Seal Puller # PTW1219 and...
    view full answer...

  • Replacement Circuit Board For A MaxxAir MaxxFan In A 2021 Grand Design Solitude 3540 5th Wheel
  • Since multiple MaxxAir Fans have the same features that you listed it's honestly best to first determine the exact model number you have before purchasing anything and end up not having it be compatible. I've listed below all the available circuit boards for the each model, if you have a tag on the vent listing the model number then we can identify the correct replacement. If not, you'll need to pull the circuit board and find the sticker on it that lists the model number. Once I have either...
    view full answer...